Simplify 3d prusa i3 mk3 model3/8/2024 ![]() ![]() I guess I'm learning some gcode whether I want to or not. Note: This file set is an extension to the HomeCube enclosure project. If there are temp changes on the 2nd or other layers, these still work.īTW I also had to add a command to the post processing section in order to get S3D to send gcode to Octoprint automatically. S3D will not issue anymore temp commands if there are temp commands in the starting script so there is no worry about override. M104 S T0 set target extruder temperature This was the solution.I put these commands in the starting script: If you want change that, just go to S3D custom gcode scripts and put the M104 and M140 in first, and pass the M190 and M109 below I use Slic3r and i have change that way too for better care of PSU and also to keep PINDA a bit more cold when pre heat ABS with long times because of bed. As I have around 550 models (as designing wargames models for 3D printing is my day job), I have continued to use that, simply because of the supports. They do that because not every printer have a full capable PSU to keep both heaters at full power, thats more a thing of old printers, still i recommend to keep it that way, because Prusa mk3 psu is underpowered when printer is on rage heat process. I previously used a Replicator 2 for several years, and used Simplif圓D for the slicing software. Thats not a problem, is the way S3D works by default. Answered: Re: Simplify 3D bed heats first then the extruder ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |